* Remove noop CANNED_MESSAGE_MODULE_ENABLE define
* Remove over-eager warning removal
* Remove unused LED_CONN
* Dead defines removal
* Rename oddball LED pin name
* Rename second oddball LED pin name
* Remove another dead define
- STM32WLE5CCU6
- NFC (unsupported): NXP NT3H2211W0FTTJ (NTAG I2C plus: NFC Forum T2T with I2C interface, password protection and energy harvesting)
- Sensor (unsupported): Analog ADuCM355 (SHTC3 is connected to ADuCM355 and not directly accessible)
- Bicolor LED
- User button (presently not functional in STM32 variants)
The definitions for sensor voltage control are present but commented out to save power, due to lack of sensor support.
Powered by 4x 4000mAh RAMWAY ER18505 Li-SOCl2 batteries.
Flashing:
1. Power down device (remove batteries)
2. Connect USB-UART to J1 (USART2), pinout is below, do not connect +3V3 pin yet
3. Short BOOT pins next to J1
4. Connect +3V3 pin or insert batteries while BOOT pins are shorted
5. Use STM32CubeProgrammer, connect by UART mode
6. Load firmware .hex and download
J1 (USART2); Molex Picoblade (P=1.25mm * 4)
1. +3V3
2. PA3_USART2_RX_J1
3. PA2_USART2_TX_J1
4. GND
Signed-off-by: Andrew Yong <me@ndoo.sg>
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* Just set LED_BUILTIN universally to -1, as we don't use it.
* LUD_BUILTIN workarounds
* Squash the LED_BUILTINs that sneaked in
* Don't kill valid pin derfine
* Minimesh Lite Added
* Add Minimesh Lite NRF
* Added board_level = extra
* Fix formatting and optimize image for Minimesh Lite
* Change image
* The image has been deleted.
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* Make BLE TX power configurable for nRF52 variants
* Include BLE TX power setting in T114 variant.h as tested
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* run trunk fmt -a
* fix bracket bug
This was introduced by @tedwardd and @thebentern in 021106dfe5.
See this diff:
else
+ checkConfigPort = false;
printf("Using config file %d\n", TCPPort);
* Initial commit of combined BLE and WiFi OTA
* Incorporate ota_hash in AdminMessage protobuf
* OTA protobuf changes
* Trunk fmt
* Partition header check for OTA type
* Guards
* Guards
* Derp
* Missed one
---------
Co-authored-by: Jake-B <jake-b@users.noreply.github.com>
* Preliminary Thinknode M4 Support
* oops
* Fix RF switch TX configuration
* trunk'd
* GPS fix for M4
* Battery handling and LED for M4
* Trunk
* Drop debug warnings
* Make Red LED notification
* Merge cleanup
* Make white LEDs flash during charge
---------
Co-authored-by: Jonathan Bennett <jbennett@incomsystems.biz>
