Add interrupt for external charge detection

Tested on Thinknode m4, m6, and T1000-e

src/Power.cpp

@@ -723,6 +723,16 @@ bool Power::setup()
             runASAP = true;
         },
         CHANGE);
+#endif
+#ifdef EXT_CHRG_DETECT
+    attachInterrupt(
+        EXT_CHRG_DETECT,
+        []() {
+            power->setIntervalFromNow(0);
+            runASAP = true;
+            BaseType_t higherWake = 0;
+        },
+        CHANGE);
 #endif
     enabled = found;
     low_voltage_counter = 0;

src/modules/StatusLEDModule.cpp

@@ -50,10 +50,9 @@ int StatusLEDModule::handleStatusUpdate(const meshtastic::Status *arg)
             break;
         }
         case meshtastic::BluetoothStatus::ConnectionState::CONNECTED: {
-            if (ble_state != connected) {
-                ble_state = connected;
-                PAIRING_LED_starttime = millis();
-            }
+            ble_state = connected;
+            PAIRING_LED_starttime = millis();
+            break;
         }
         }
 

variants/nrf52840/heltec_mesh_solar/platformio.ini

@@ -16,7 +16,7 @@ lib_deps =
   # renovate: datasource=git-refs depName=NMIoT-meshsolar packageName=https://github.com/NMIoT/meshsolar gitBranch=main
   https://github.com/NMIoT/meshsolar/archive/dfc5330dad443982e6cdd37a61d33fc7252f468b.zip
   # renovate: datasource=custom.pio depName=ArduinoJson packageName=bblanchon/library/ArduinoJson
-  bblanchon/ArduinoJson@7.4.2
+  bblanchon/ArduinoJson@6.21.5
 
 [env:heltec-mesh-solar]
 custom_meshtastic_hw_model = 108

variants/nrf52840/rak4631_eth_gw/platformio.ini

@@ -36,7 +36,7 @@ lib_deps =
   # renovate: datasource=git-refs depName=RAK12034-BMX160 packageName=https://github.com/RAKWireless/RAK12034-BMX160 gitBranch=main
   https://github.com/RAKWireless/RAK12034-BMX160/archive/dcead07ffa267d3c906e9ca4a1330ab989e957e2.zip
   # renovate: datasource=custom.pio depName=ArduinoJson packageName=bblanchon/library/ArduinoJson
-  bblanchon/ArduinoJson@7.4.2
+  bblanchon/ArduinoJson@6.21.5
 ; If not set we will default to uploading over serial (first it forces bootloader entry by talking 1200bps to cdcacm)
 ; Note: as of 6/2013 the serial/bootloader based programming takes approximately 30 seconds
 ;upload_protocol = jlink