- STM32WLE5CCU6
- NFC (unsupported): NXP NT3H2211W0FTTJ (NTAG I2C plus: NFC Forum T2T with I2C interface, password protection and energy harvesting)
- Sensor (unsupported): Analog ADuCM355 (SHTC3 is connected to ADuCM355 and not directly accessible)
- Bicolor LED
- User button (presently not functional in STM32 variants)
The definitions for sensor voltage control are present but commented out to save power, due to lack of sensor support.
Powered by 4x 4000mAh RAMWAY ER18505 Li-SOCl2 batteries.
Flashing:
1. Power down device (remove batteries)
2. Connect USB-UART to J1 (USART2), pinout is below, do not connect +3V3 pin yet
3. Short BOOT pins next to J1
4. Connect +3V3 pin or insert batteries while BOOT pins are shorted
5. Use STM32CubeProgrammer, connect by UART mode
6. Load firmware .hex and download
J1 (USART2); Molex Picoblade (P=1.25mm * 4)
1. +3V3
2. PA3_USART2_RX_J1
3. PA2_USART2_TX_J1
4. GND
Signed-off-by: Andrew Yong <me@ndoo.sg>
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* Just set LED_BUILTIN universally to -1, as we don't use it.
* LUD_BUILTIN workarounds
* Squash the LED_BUILTINs that sneaked in
* Don't kill valid pin derfine
I thought git would be smart enough to understand all the whitespace changes but even with all the flags I know to make it ignore theses it still blows up if there are identical changes on both sides.
I have a solution but it require creating a new commit at the merge base for each conflicting PR and merging it into develop.
I don't think blowing up all PRs is worth for now, maybe if we can coordinate this for V3 let's say.
This reverts commit 0d11331d18.
Remove lib_deps section for all PlatformIO envs which are unneeded (only references the `extends` lib_deps, thus pointless)
This makes the configs more concise and make future PIO variants/ libdeps audits easier.
Also move RAK3172 and new EBYTE_E77_MBL define to variant.h, as this makes VSCode know about the defines properly...
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* Show ExternalNotification as excluded if it is
* Enable ExternalNotification, SerialModule and RangeTest on STM32WL
* Misc fixes for #7797 - ARCH_STM32 -> ARCH_STM32WL, use less flash by dropping weather station support for serialmodule, set tx/rx pins before begin
* Enable Serial1 on RAK3172, make SerialModule use it (console is on LPUART1)
* Fix SerialModule on RAK3172, fix board definition of RAK3172 to include the right pin mapping.
