* * Update RAK9154 sensor to tx remote power telemetry
* remove uf2 script, pio run does that inline
* move sensor module to correct position
* disable LED and Accelerometer code on rak2560
* trunk fmt
* mention epaper variant
* attention, revert, revert
* Enable Environment Telemetry of these values
* fix float values
* Initiate magenetometer based compass calibration from button presses
- only active for BMX160 accelerometers on RAK_4631
- replace automatic calibration on power on with button triggered
calibration
- set 5 presses to trigger 30s calibration
- set 6 presses to trigger 60s calibration (useful if unit is not
handheld, ie vehicle mounted)
- show calibration time remaining on calibration alert screen
* Fix non RAK 4631 builds
- exclude changes from non RAK 4631 builds
- remove calls to screen when not present
* Fix build on RAK4631_eth_gw
- exclude all compass heading updates on variant without screen
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
As reported by @Mason10198, the WisMesh Pocket was always waking
on accelerometer motion.
This change gates the LIS3DH sensor's call to wakeScreen based on
config.display.wake_on_tap_or_motion .
fixes https://github.com/meshtastic/firmware/issues/5579
* T1000-E Peripherals
- enable intelligent charge controller signals
- enable Accelerometer
- enable internal I2C bus
- provide Power to Accelerometer
* POC Accelerometer Code (wakeScreen is moot for that device, just test if the driver works)
* fix building without the sensor
remove newline from logging statements in code. The LOG_* functions will now magically add it at the end.
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
