Add RAK WisMesh Tap V2 (ESP32S3) Hardware Variant (#7741)

* Add initial variant and platformio configuration for RAK WISMESHTAP V2

* Add initial variant and platformio configuration for rak wismesh tap v2

* Remove unnecessary Meshtastic build flags from rak_wismesh_tap_v2 configuration

* Enable LGFX button support in rak_wismesh_tap_v2 configuration

* Revert "Enable LGFX button support in rak_wismesh_tap_v2 configuration"

This reverts commit 2bd2c1a03b.

---------

Co-authored-by: Daniel.Cao <daniel.cao@rakwireless.com>

variants/esp32s3/rak_wismesh_tap_v2/variant.h

@@ -0,0 +1,71 @@
+#ifndef _VARIANT_RAK_WISMESHTAP_V2_H
+#define _VARIANT_RAK_WISMESHTAP_V2_H
+
+#define I2C_SDA 9
+#define I2C_SCL 40
+
+#define USE_SX1262
+
+#define LORA_SCK 5
+#define LORA_MISO 3
+#define LORA_MOSI 6
+#define LORA_CS 7
+#define LORA_RESET 8
+
+#ifdef USE_SX1262
+#define SX126X_CS LORA_CS
+#define SX126X_DIO1 47
+#define SX126X_BUSY 48
+#define SX126X_RESET LORA_RESET
+#define SX126X_DIO2_AS_RF_SWITCH
+#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+#endif
+
+#define SX126X_POWER_EN (4)
+
+#define PIN_POWER_EN PIN_3V3_EN
+#define PIN_3V3_EN (14)
+
+#define LED_GREEN 46
+#define LED_BLUE 45
+
+#define PIN_LED1 LED_GREEN
+#define PIN_LED2 LED_BLUE
+
+#define LED_CONN LED_BLUE
+#define LED_PIN LED_GREEN
+#define ledOff(pin) pinMode(pin, INPUT)
+
+#define LED_STATE_ON 1 // State when LED is litted
+
+#define HAS_GPS 1
+#define GPS_TX_PIN 43
+#define GPS_RX_PIN 44
+
+#define SPI_MOSI (11)
+#define SPI_SCK (13)
+#define SPI_MISO (10)
+#define SPI_CS (12)
+
+#define HAS_BUTTON 1
+#define BUTTON_PIN 0
+
+#define CANNED_MESSAGE_MODULE_ENABLE 1
+#define USE_VIRTUAL_KEYBOARD 1
+
+#define BATTERY_PIN 1
+#define ADC_CHANNEL ADC1_GPIO1_CHANNEL
+#define ADC_MULTIPLIER 1.667
+
+#define PIN_BUZZER 38
+
+#define HAS_SDCARD 1
+#define SDCARD_USE_SPI1 1
+#define SDCARD_CS  2
+
+#define SPI_FREQUENCY 40000000
+#define SPI_READ_FREQUENCY 16000000
+
+#define SD_SPI_FREQUENCY 50000000
+
+#endif