new receive code works a little better

docs/software/nrf52-TODO.md

@@ -9,7 +9,10 @@ Minimum items needed to make sure hardware is good.
 - DONE basic test of BLE
 - DONE get a debug 'serial' console working via the ICE passthrough feature
 - add a hard fault handler
-- switch to RadioLab? test it with current radio. https://github.com/jgromes/RadioLib
+- DONE switch to RadioLab? test it with current radio. https://github.com/jgromes/RadioLib
+- change rx95 to radiolib
+- track rxbad, rxgood, txgood
+- neg 7 error code from receive
 - at boot we are starting our message IDs at 1, rather we should start them at a random number. also, seed random based on timer. this could be the cause of our first message not seen bug
 - use SX126x::startReceiveDutyCycleAuto to save power by sleeping and briefly waking to check for preamble bits. Change xmit rules to have more preamble bits.
 - use "variants" to get all gpio bindings
@@ -51,6 +54,7 @@ Needed to be fully functional at least at the same level of the ESP32 boards. At
 
 ## Items to be 'feature complete'
 
+- remove the MeshRadio wrapper - we don't need it anymore, just do everythin in RadioInterface subclasses.
 - figure out what the correct current limit should be for the sx1262, currently we just use the default 100
 - put sx1262 in sleepmode when processor gets shutdown (or rebooted), ideally even for critical faults (to keep power draw low). repurpose deepsleep state for this.
 - good power management tips: https://devzone.nordicsemi.com/nordic/nordic-blog/b/blog/posts/optimizing-power-on-nrf52-designs