Add t-echo plus support

src/main.cpp

@@ -205,7 +205,7 @@ ScanI2C::FoundDevice rgb_found = ScanI2C::FoundDevice(ScanI2C::DeviceType::NONE,
 /// The I2C address of our Air Quality Indicator (if found)
 ScanI2C::DeviceAddress aqi_found = ScanI2C::ADDRESS_NONE;
 
-#if defined(T_WATCH_S3) || defined(T_LORA_PAGER)
+#ifdef HAS_DRV2605
 Adafruit_DRV2605 drv;
 #endif
 
@@ -788,7 +788,6 @@ void setup()
     // We do this as early as possible because this loads preferences from flash
     // but we need to do this after main cpu init (esp32setup), because we need the random seed set
     nodeDB = new NodeDB;
-
 #if HAS_TFT
     if (config.display.displaymode == meshtastic_Config_DisplayConfig_DisplayMode_COLOR) {
         tftSetup();
@@ -834,7 +833,12 @@ void setup()
 #endif
 #endif
 
-#if defined(T_WATCH_S3) || defined(T_LORA_PAGER)
+#ifdef HAS_DRV2605
+#if defined(PIN_DRV_EN)
+    pinMode(PIN_DRV_EN, OUTPUT);
+    digitalWrite(PIN_DRV_EN, HIGH);
+    delay(10);
+#endif
     drv.begin();
     drv.selectLibrary(1);
     // I2C trigger by sending 'go' command
@@ -870,7 +874,7 @@ void setup()
     SPI.begin();
 #endif
 #else
-        // ESP32
+// ESP32
 #if defined(HW_SPI1_DEVICE)
     SPI1.begin(LORA_SCK, LORA_MISO, LORA_MOSI, LORA_CS);
     LOG_DEBUG("SPI1.begin(SCK=%d, MISO=%d, MOSI=%d, NSS=%d)", LORA_SCK, LORA_MISO, LORA_MOSI, LORA_CS);