ESP32s3: Migrate variants to new structure (#7343)

variants/esp32s3/heltec_sensor_hub/variant.h

@@ -0,0 +1,48 @@
+#define EXT_PWR_DETECT 20
+
+#define BUTTON_PIN 17
+#define BUTTON_ACTIVE_LOW false
+#define BUTTON_ACTIVE_PULLUP false
+
+#define BATTERY_PIN 7 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
+#define ADC_CHANNEL ADC1_GPIO7_CHANNEL
+#define ADC_ATTENUATION ADC_ATTEN_DB_2_5 // lower dB for high resistance voltage divider
+#define ADC_MULTIPLIER (4.9 * 1.045)
+#define ADC_CTRL 34 // active HIGH, powers the voltage divider. Only on 1.1
+#define ADC_CTRL_ENABLED HIGH
+
+#define HAS_NEOPIXEL                         // Enable the use of neopixels
+#define NEOPIXEL_COUNT 1                     // How many neopixels are connected
+#define NEOPIXEL_DATA 18                     // gpio pin used to send data to the neopixels
+#define NEOPIXEL_TYPE (NEO_GRB + NEO_KHZ800) // type of neopixels in use
+
+#define USE_SX1262
+#define LORA_DIO0 RADIOLIB_NC
+#define LORA_RESET 12
+#define LORA_DIO1 14 // SX1262 IRQ
+#define LORA_DIO2 13 // SX1262 BUSY
+
+#define LORA_SCK 9
+#define LORA_MISO 11
+#define LORA_MOSI 10
+#define LORA_CS 8
+
+#define SX126X_CS LORA_CS
+#define SX126X_DIO1 LORA_DIO1
+#define SX126X_BUSY LORA_DIO2
+#define SX126X_RESET LORA_RESET
+
+#define SX126X_DIO2_AS_RF_SWITCH
+#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+
+#define I2C_SDA 1
+#define I2C_SCL 2
+#define HAS_SCREEN 0
+#define SENSOR_POWER_CTRL_PIN 33
+#define SENSOR_POWER_ON 1
+
+#define PERIPHERAL_WARMUP_MS 100
+
+#define ESP32S3_WAKE_TYPE ESP_EXT1_WAKEUP_ANY_HIGH
+
+#define ENVIRONMENTAL_TELEMETRY_MODULE_ENABLE 1