src/RF95Configuration.h

// TODO refactor this out with better radio configuration system
#ifdef USE_RF95
#define RF95_RESET LORA_RESET
#define RF95_IRQ LORA_DIO0  // on SX1262 version this is a no connect DIO0
#define RF95_DIO1 LORA_DIO1 // Note: not really used for RF95, but used for pure SX127x
#define RF95_DIO2 LORA_DIO2 // Note: not really used for RF95
#endif
Initial configuration.h -> variants refactor (#1104) * Initial configuration to variants refactor 2022-01-18 18:35:42 -06:00			`// TODO refactor this out with better radio configuration system`
			`#ifdef USE_RF95`
			`#define RF95_RESET LORA_RESET`
			`#define RF95_IRQ LORA_DIO0 // on SX1262 version this is a no connect DIO0`
Use LORA_DIO1 as RadioLib GPIO for SX127x chips (#2290) * When channel is active, first try receiving that packet Afterwards we'll try transmitting again * Remove setStandby in startSend Already done in isChannelActive() * Set LORA_DIO1 as RadioLib GPIO for SX127x * LORA_DIO1 for Heltec v1, overlaps with GPS_TX Set to RADIOLIB_NC for now * If receive was not successful, startReceive doesn't trigger the interrupt So we have to go back to transmitting anyway --------- Co-authored-by: Ben Meadors <benmmeadors@gmail.com> 2023-02-20 14:40:44 +01:00			`#define RF95_DIO1 LORA_DIO1 // Note: not really used for RF95, but used for pure SX127x`
Initial configuration.h -> variants refactor (#1104) * Initial configuration to variants refactor 2022-01-18 18:35:42 -06:00			`#define RF95_DIO2 LORA_DIO2 // Note: not really used for RF95`
			`#endif`