src/mesh/SX1262Interface.cpp

#if RADIOLIB_EXCLUDE_SX126X != 1
#include "SX1262Interface.h"
#include "configuration.h"
#include "error.h"

SX1262Interface::SX1262Interface(LockingArduinoHal *hal, RADIOLIB_PIN_TYPE cs, RADIOLIB_PIN_TYPE irq, RADIOLIB_PIN_TYPE rst,
                                 RADIOLIB_PIN_TYPE busy)
    : SX126xInterface(hal, cs, irq, rst, busy)
{
}
#endif
Allow for better target level Radiolib exclude plumbing (#4906) * WIP * LR11x0 * Anothern * =1 2024-09-30 05:14:22 -05:00			`#if RADIOLIB_EXCLUDE_SX126X != 1`
cleanup so eventually rf95 can share common msg code with sx1262 2020-04-29 16:28:11 -07:00			`#include "SX1262Interface.h"`
trunk roundhouse kick 2023-01-21 14:34:29 +01:00			`#include "configuration.h"`
fix #577 don't make invalid radio settings reboot the board instead raise a critical fault (note though: this is still not ideal because the radio will be in an undefined state until valid settings are used) 2020-12-27 13:09:20 +08:00			`#include "error.h"`
cleanup so eventually rf95 can share common msg code with sx1262 2020-04-29 16:28:11 -07:00
RadioLib6 support 2023-05-08 13:18:28 +02:00			`SX1262Interface::SX1262Interface(LockingArduinoHal *hal, RADIOLIB_PIN_TYPE cs, RADIOLIB_PIN_TYPE irq, RADIOLIB_PIN_TYPE rst,`
			`RADIOLIB_PIN_TYPE busy)`
			`: SX126xInterface(hal, cs, irq, rst, busy)`
we now hopefully apply the same radio settings as we did for the RF95 2020-04-29 18:46:32 -07:00			`{`
Allow for better target level Radiolib exclude plumbing (#4906) * WIP * LR11x0 * Anothern * =1 2024-09-30 05:14:22 -05:00			`}`
			`#endif`